Locks can be frustrating to get open. You may have tried all of the tricks you know, or maybe you’re just not very good at puzzles. But don’t worry – there’s an easier way. In this article, we’ll show you how to drill out a lock with a simple handgun.
Tools Required
The tools you’ll need to drill out a lock vary depending on the lock.
For most standard door locks, you will need a drill, a bit, and a wrench.
For more complicated or specialized locks, like deadbolt locks or keypadlocks, you might also need a screwdriver or an Allen key.
Before you start drilling, make sure to read the manufacturer’s instructions for the lock. Some locks require special techniques that will void your warranty if not followed.
How to Drill Out a Lock
There are a variety of ways to drill out a lock, depending on the type of lock and the size of the hole required.
If the lock is a standard pin tumbler lock, use a drill with a bit that is slightly larger than the pins in the lock. Turn the drill slowly at first, then increase the speed as the bit starts to cut into the pins. Once all of the pins have been removed, use a screwdriver to pry open the door.
If the lock is a cylinder keylock, use a drill with a bit that is slightly smaller than the cylinder key. Insert the key into the lock and turn it until it clicks into place. Use a magnifying glass to see where each screw goes. Drill out each screw from underneath, then use a screwdriver to pry open the door.
Tips for Safe Drilling
When it comes to repairing or replacing locks, the first step is always to identify the lock type. Locks come in many varieties, some of which are easier to drill out than others.
If you’re attempting to drill out a standard pin tumbler lock, start by locating the keyhole and lining up the bit with it. Be sure the bit is centered and make an even hole. Start by drilling slowly and evenly until you reach the bolt that holds the door closed. Once you’ve reached this bolt, use a punch to break it off and remove the lock.
If you’re drilling out a wafer-type lock, start by cutting off one of the cylinder’s pins so that it can rotate freely. It’s also helpful to get a replacement key so that you can match up the pins correctly. Now stands between the door and frame and uses a drill bit slightly larger than the pin size. Begin drilling from one side of the pin until it pops out. Repeat on the other side. Be sure to keep your fingers well away from the spinning cylinder; otherwise you could get seriously injured!
Conclusion
If you have ever had the misfortune of having your bike or car stolen, then you know that finding a way to secure your possessions is essential. Unfortunately, many people don’t realize that securing their property with a lock isn’t as difficult as they might think. This article will teach you how to drill out a standard bicycle lock, and if you need help fixing your lock once it has been drilled, we’ve included instructions on how to do that too. So whether you want to make sure your bike doesn’t get stolen again or just want to be extra safe when leaving your house, learning how to drill out a lock is an important step in the right direction.
